VLAN no working on WS-12-250B

[smaicas]

At this point I do not think I have explained well what the problem is because if the Netonix is presented as an improvement over UBNT equipment. Something that works with UBNT with default values and a basic set swith should be possible with a device of this kind.
Basically, we need the Netonix let different VLAN traffic and not make a filter / traffic court thereof. With other devices work with the defaults, but if the Netonix must do so in a specific way would appreciate a short manual or example.
To date I have made several tests such as T brand a VLAN to pass traffic but it has not worked.
PS: From within the web interface in the MAC TABLE option, the devices appear with the correct VLAN.
Everything indicates that for some reason is leaking when traffic is marked by a VLAN
The final situation is as follows





PORT 1 à LINK OVER UBNT M10 LINK 1
PORT2 à LINK OVER UBNT M10 LINK 2
PORT5 à AP5 TRAFIC OVER LINK M10 LINK 2
PORT7/8 à AP5_2 TRAFIC OVER LINK M10 LINK 1

PORT5 / 7 /8 ARE MIKROTIK AP 5GHZ WITH CLIENTES THAN USE VLAN 101 /102 Tagged on wireless INTERFACE

Espero que con esta explicación quede clara la necesidad para nuestra red

[sirhc]

Hi smaicas,

I am not sure what to tell you.

I see your configuration above which is not how I would set it up. You are relying on the laxed VLAN configuration of the ToughSwitch.

Below is a crude Diagram

Is this what your wanting to do?

If not please modify it then I will propose a configuration

[smaicas]

a few notes

Clients of AP 's can open the connection without using VLAN or using VLAN101 or VLAN102

The AP1 routes your traffic by ether1 (link1) and AP2 . I made a VLAN(200) Untagged for on port 1-7 an other o vlan201 on port 2-8



Thanks for you help