v2.0.10 Bug Reports and Comments

[Stephen]

Click HERE to download firmware v2.0.10 - Released 10/04/2026

FIXED / CHANGED:
- PHP Upgraded to 8.3.36
- security patch for 8.3.36 to fix PHP CVE-2026-109618/-109619) added to upgraded build. (in other words, this fixes the recent and now infamous "PHP2Shell" exploit)

KNOWN ISSUES:
- IPv6 is disabled pending investigation.
- IGMP Snooping has been found to cause instability with STP, it has been disabled pending investigation.
- Enabling D-VLAN on a port can lock up the switch.
- If you have an OCP on a port try using a different port to see if it’s a bad port or the problem follows the cable.
- WEB UI issues when not at 100% Zoom on browser, especially on the VLAN tab.
- Some language templates need help
.
Released 10/04/2026

[elcano89]

Hi Stephen,

I sent you a PM and email over the forum about the WS3 firmware. I have around 16 of these switches in production for almost 2 years now and have collected very good data. I worked with the translations, specially the Spanish one (my native language) and most of the major issues. I left my email at the bottom of the message if needed.

[Julian]

Not an issue for my use case, but just noticed that 'total power' indicator under main status in the GUI doesn't seem to be totalling properly on my WS3; Haven't checked SNMP-side to see the relevant OID's return status but this maff ain't maffin'..

https://imgur.com/mcSOHMh
50W draw on the test 450m, total at 15w

https://imgur.com/k93rcJT
further 10w draw, total still at 15w