RJ45 feed-through ends

RF Armor®™ is not associated with Netonix® in any way.
User avatar
lligetfa
Associate
Associate
 
Posts: 1186
Joined: Sun Aug 03, 2014 12:12 pm
Location: Fort Frances Ont. Canada
Has thanked: 305 times
Been thanked: 381 times

RJ45 feed-through ends

Sat Mar 02, 2019 12:31 pm

Any plans to offer a feed-through version? I don't know if they are protected by patent and so would need to be licensed.

I recently purchased the feed-through crimper and should mention that it was not for the ease of crimping as I have no problem to do it the old school way. The reason was more to have the cable jacket compressed rather than stretched.

When crimping old-school, I pull outward on the wires to compress the jacket and then keep pressure on the jacket to keep the wires from pulling back in while inserting/crimping. I figure with the feed-through, I can have more compression on the jacket although I'm not sure I really need to since I very seldom have a jacket pull out.

Also, ISTR past discussions on the contacts being IPC and not IDC. IPC being the two points that pierce versus IDC being three fingers that displace. I have a strong preference for 3 finger IDC.

User avatar
lligetfa
Associate
Associate
 
Posts: 1186
Joined: Sun Aug 03, 2014 12:12 pm
Location: Fort Frances Ont. Canada
Has thanked: 305 times
Been thanked: 381 times

Re: RJ45 feed-through ends

Sat Mar 02, 2019 1:25 pm

lligetfa wrote:I don't know if they are protected by patent and so would need to be licensed...


Looks like Ideal is going after Platinum in this regard.

https://www.scribd.com/document/1361216 ... inum-Tools

BTW, I have the Ideal crimper.

Return to RF Armor™

Who is online

Users browsing this forum: No registered users and 6 guests