UBNT PoE Factory Default Reset...

Help us decide what to build next.
User avatar
LRL
Experienced Member
 
Posts: 238
Joined: Sun Nov 23, 2014 4:00 am
Location: Rock Springs, WY
Has thanked: 18 times
Been thanked: 49 times

Re: UBNT PoE Factory Default Reset...

Wed Oct 12, 2016 12:03 pm

I mostly we just add 192.168.1.1/24 as a secondary like Chris does, but I get brave (or stupid(you decide)) and redistribute that route via ospf. The only issue we've ever ran into was I forgot to remove it on one tower after a 2am issue and I had a customer try very very hard to login to their router...
-LRL

"My reading of history convinces me that most bad government results from too much government." - Thomas Jefferson

User avatar
rebelwireless
Experienced Member
 
Posts: 607
Joined: Mon Sep 01, 2014 1:46 pm
Has thanked: 31 times
Been thanked: 136 times

Re: UBNT PoE Factory Default Reset...

Wed Oct 12, 2016 1:43 pm

Yeah, I wish ubnt would have chosen a different subnet like tik (192.168.88.1/24)

User avatar
mike99
Associate
Associate
 
Posts: 837
Joined: Tue Nov 25, 2014 10:53 am
Location: Quebec, Canada
Has thanked: 95 times
Been thanked: 245 times

Re: UBNT PoE Factory Default Reset...

Wed Oct 19, 2016 9:01 am

Cambium ePMP factory reset could probably easily be scripted into a netonix since it's based on multiple cycled reboots.

From manual (fw 2.6.2.1)
1 - Remvoe the Ethernet cable form PoE jack of the power supply ofr at least 10 seconds.
2 - Reconnect the Ethernet cable to re-supply power to the ePMP device for 3-5 secondes and disconnect calbe to power off the ePMP device for 3-5 secondes. (1st power cycle)
3 - Reconnect the Ethernet cable to re-supply power to the ePMP device for 3-5 secondes and disconnect calbe to power off the ePMP device for 3-5 secondes. (2st power cycle)
4 - Reconnect the Ethernet cable to re-supply power to the ePMP device for 3-5 secondes and disconnect calbe to power off the ePMP device for 3-5 secondes. (3st power cycle)
5 - Reconnect the Ethernet cable to re-supply power to the ePMP device for 3-5 secondes and disconnect calbe to power off the ePMP device for 3-5 secondes. (4st power cycle)
6 - Reconnect the Ethernet cable to re-supply power to the ePMP device for at least 30 secondes and allow it to go through the boot up procedure. (Note: Device will go through an additionnal reset automaticlly). This will reset the current configuration files to factory default configuration (e.g. Ip addresses, Device mode, RF configuration etc.).

Previous
Return to What should we build next

Who is online

Users browsing this forum: No registered users and 15 guests