Netonix Forums

Hi:

24 VH WS-24-400-A ? I need to connect a Fiber 5 X in this Netonix but... I hope to find this option in a new firmware... pse...

Thank you.

OK maybe you should read this post: viewtopic.php?f=6&t=1215

As you can see you can power AFX radios with 24V, 24VH, 48V and 48VH

There are a lot of AF5x being installed, and those are 24v. I would think two might not be enough.

Why would you power an AFX radio with 24VH instead of 48VH?

Please read these posts:
viewtopic.php?f=6&t=2013&p=16324&hilit=AFX#p16324
viewtopic.php?f=12&t=1960&p=16147&hilit=AFX#p16147

The AF5X can be powered by:
24V up to 160 feet +/- of cable < Least prefered method
48V up to 200 feet +/- of cable < Better method
24VH up to 326 feet +/- of cable < Even better method
48VH up to 326 feet +/- of cable < Preferred method

The AFX radios can actually use all 4 POE options we have as seen above.

A list of all the POE options is provided in the spec sheet and on the product description on our web store.
24VH is not offered on the WS-24-400A BUT YOU DO NOT NEED IT

Hi:
Thank you very much for you information . I didn't know ubnt poe table. I've an AF5x working fine with ws-12-250-dc at 24hv in a tower with sun power. It is an amazing switch...great job... but I always take note about tec. Spec..before connect any device...they are very expensive ...and af5x data sheet and poe that comes inside box is 24v 1Amp.

Thank you for your help...

Best regards.