Focussed voltage read-out on the DC switches
Posted: Wed Dec 07, 2016 9:42 am
Input voltage graph on the DC switches are a nice feature I actually myself applied for in this forum. No complaints so far..
But if possible in next firmware release could it be made such we can 'zooom' into the level of interest?
I mean, Battery voltage between 22 and 28 is all we need to know. Higher than that and the batteries are smoking.. any lower than 22 means they are virtually dead....
Now with the 0-30V range the daily movement on a solar instalation (from +28 during the day to +24,5 on a normal night is only giving a rimple in the actual graph.
It the graph could be zoomed in to that range or just taken the lower 20volt of the scale the graph would be much more helpful to look at.
So no urgency, more a ergonomic improvement.....
But if possible in next firmware release could it be made such we can 'zooom' into the level of interest?
I mean, Battery voltage between 22 and 28 is all we need to know. Higher than that and the batteries are smoking.. any lower than 22 means they are virtually dead....
Now with the 0-30V range the daily movement on a solar instalation (from +28 during the day to +24,5 on a normal night is only giving a rimple in the actual graph.
It the graph could be zoomed in to that range or just taken the lower 20volt of the scale the graph would be much more helpful to look at.
So no urgency, more a ergonomic improvement.....