Netonix Forums

Hello,
I have managed to lose access to switch by not marking ether1 to handle tagged vlans (1,100). typically i would reset and start again but it has been setup with no recent backups.
how do i modify the vlans via the terminal (usb to serial). oddly it is passing the vlans to other switches on the network?

Thank you,

Well connect to the switch via serial cable.

The CLI has online help to guild you through sorta like cisco CLI does.

Please post a link to the documentation, I can't find it anywhere

sw02# show vlan
ID Enable Description 1 2 3 4 5 6
---- ------ ----------- -- -- -- -- -- --
100 true Management T T T T T T
1 true default T U U U U U

i need to change the vlan assignment on a port

DolphinComms wrote:sw02# show vlan
ID Enable Description 1 2 3 4 5 6
---- ------ ----------- -- -- -- -- -- --
100 true Management T T T T T T
1 true default T U U U U U

i need to change the vlan assignment on a port

All the help you needed is provided under the CLI with ?

Your in the CLI
Get to config mode with "config" [Enter]
Get to VLAN 100 with "VLAN 100" [Enter]
Set port tagging on current VLAN (100) with "Port 1 U" [Enter]
Save / Apply changes "Ctrl + z"

Remember the Management VLAN is ALWAYS the TOP VLAN no matter what number you assign to it.

Someone helped me and here is what I did

configure
vlan [ID]
port [NUMBER] U/Q/T/E

U - Untagged
Q - QinQ
T - Tagged
E - Exclude

To fix my issue

configure
vlan 1
port 5 U
end

i love these switches