Netonix Forums

Hi,

I need to put some time delay on PoE port activation and I was wonder if there is an option for Time delay in PoE Management on that particular switch? Or is there a way using CLI/SSH to configure that with commands?

Kind regards
Evan

Yes, in the Power Tab, you can input in seconds to the Boot Start Delay for a port and when the switch boots it will not turn on PoE on that port for the specified time.

Thanks for the reply Stephen
We have been using that setting for some netonix on the field and it works great. However is there a suggested time I should put between ports delay?
For example we have 3 PoE ports and I do the following:

Port Boot Start Delay
1 15
2 5
3 10

They boot up all at the same time still. I would expect 15 seconds on port 1 delay etc.

The version on that switch is v1.5.2

Kind regards
Evan