Rx Drops on SFP port

corey.b
Member
 
Posts: 11
Joined: Mon May 21, 2018 12:05 pm
Has thanked: 0 time
Been thanked: 0 time

Rx Drops on SFP port

Mon Jun 24, 2019 8:58 am

We are getting Rx drops on our SFP port coming out of our router into the netonix. I am not sure what else it could be. We have changed out the router, SFP's, Netonix, and fiber jumper and it still gets Rx drops. Attached is a pic of the drops. I am not sure what else it could be.

Thanks,
Corey B.
Attachments
Capture.PNG

User avatar
mike99
Associate
Associate
 
Posts: 837
Joined: Tue Nov 25, 2014 10:53 am
Location: Quebec, Canada
Has thanked: 95 times
Been thanked: 245 times

Re: Rx Drops on SFP port

Mon Jun 24, 2019 7:05 pm

Unknow VLAN ? Could you post both vlan config ?

corey.b
Member
 
Posts: 11
Joined: Mon May 21, 2018 12:05 pm
Has thanked: 0 time
Been thanked: 0 time

Re: Rx Drops on SFP port

Tue Jun 25, 2019 7:57 am

Here is the vlan config. I have this setup with all the other netonix switches.
Attachments
Capture.PNG
Capture.PNG (8.03 KiB) Viewed 7134 times

User avatar
mike99
Associate
Associate
 
Posts: 837
Joined: Tue Nov 25, 2014 10:53 am
Location: Quebec, Canada
Has thanked: 95 times
Been thanked: 245 times

Re: Rx Drops on SFP port

Tue Jun 25, 2019 8:42 am

And the VLAN config from the Juniper ?

What is the MTU size on the SFP port ? Older firmware had a too small MTU by default and not have a preconfigured MTU set to 1528.

corey.b
Member
 
Posts: 11
Joined: Mon May 21, 2018 12:05 pm
Has thanked: 0 time
Been thanked: 0 time

Re: Rx Drops on SFP port

Tue Jun 25, 2019 9:11 am

Have the mtu set to 2000 on the netonix and the cisco router.

Router Config
description ** Connection to Connection to Ignyte Edge Microwave **
mtu 2000
no ip address
load-interval 30
negotiation auto
storm-control broadcast level 2.00
storm-control multicast level 2.00
storm-control action trap
qos-config scheduling-mode min-bw-guarantee
no keepalive
cdp enable
service instance 50 ethernet
description ** Connection to Customer Microwaves **
encapsulation dot1q 50
rewrite ingress tag pop 1 symmetric
bridge-domain 50

User avatar
mike99
Associate
Associate
 
Posts: 837
Joined: Tue Nov 25, 2014 10:53 am
Location: Quebec, Canada
Has thanked: 95 times
Been thanked: 245 times

Re: Rx Drops on SFP port

Tue Jun 25, 2019 8:08 pm

I look the stats and most pass through. It's really hard to figure out what is dropped.

We would need a network capture on each side to figure out what is drop or not. Coudl you try a 2008 or even more MTU on the netonix SFP port. From my experience, Neonix SFP port need a littler more than remote device MTU if this device is sending frame at full size.

Does it affect your usage ? Else, it could be rejected network control protocol packets.

corey.b
Member
 
Posts: 11
Joined: Mon May 21, 2018 12:05 pm
Has thanked: 0 time
Been thanked: 0 time

Re: Rx Drops on SFP port

Wed Jun 26, 2019 5:16 pm

I am still getting drops on it. Could it be one of the radios causing this issue you think even though I don't get the drops on those ports?

Return to General Discussion

Who is online

Users browsing this forum: No registered users and 29 guests