Finding Loops/ STP

User avatar
jar
Member
 
Posts: 9
Joined: Sun Sep 20, 2015 12:08 pm
Location: California
Has thanked: 0 time
Been thanked: 0 time

Finding Loops/ STP

Wed Jan 24, 2018 8:01 pm

Hi All,
I'm trying to figure out how best to figure out where a loop is coming from on my network. See attached diagram

All routers are mikrotiks running 6.36.4 and netonix are WS-12-250-DC and running 1.4.8 (or newer). Each of the backhaul links are on a separate networks and we route using ospf.

If I turn both radios on BH1 (have connection, OSPF sees adjacency), then BH3 goes down. The netonix sense a loop and block the port.


Sep 7 04:05:03 STP: MSTI0: New root on port 4, root path cost is 80000
Sep 7 04:05:03 STP: set port 2 to discarding

I'm pretty sure that this is NOT a netonix issue (well maybe a config issue on my side). How would I go about troubleshooting this?
Attachments
netonix diagram.jpg

User avatar
mike99
Associate
Associate
 
Posts: 837
Joined: Tue Nov 25, 2014 10:53 am
Location: Quebec, Canada
Has thanked: 95 times
Been thanked: 245 times

Re: Finding Loops/ STP

Fri Jan 26, 2018 9:07 pm

Vlans and ports config would help. Maybe print screen or just the "show vlans" command via CLI and indicate which ports are use on each switch for those 3 links.

jefa
Member
 
Posts: 11
Joined: Tue Mar 15, 2016 9:39 am
Has thanked: 0 time
Been thanked: 8 times

Re: Finding Loops/ STP

Mon Jan 29, 2018 7:28 am

STP (and RSTP) is not vlan aware.

MST can be set up with separate instances for the vlans you use. If you only use the vlan for one link (besides the trunk to the router), you could simply disable spanning-tree for the interface to the link (both ends for each vlan/link).

User avatar
mike99
Associate
Associate
 
Posts: 837
Joined: Tue Nov 25, 2014 10:53 am
Location: Quebec, Canada
Has thanked: 95 times
Been thanked: 245 times

Re: Finding Loops/ STP

Mon Jan 29, 2018 9:25 am

Not VLAN aware but still protect again loop by blocking a whole port in the ring so loop shouldn't happen. He should get RSTP right first before adding more complexity with MSTP instances.

mrmarria
Member
 
Posts: 31
Joined: Tue Oct 25, 2016 3:59 pm
Has thanked: 5 times
Been thanked: 2 times

Re: Finding Loops/ STP

Tue Aug 24, 2021 5:10 pm

This is old thread, I hope still being watched

I am having a very similar problem, what did you discover or have a solution?

My temporary solution was to take one end of a link off the netonix and put on regular poe supply, but I would like more information on the netonix settings or diagnostic to stop the actual (i suspect, invalid) loop detection.

Thanks

Return to General Discussion

Who is online

Users browsing this forum: No registered users and 18 guests