Serial commands

rzoccola
Member
 
Posts: 7
Joined: Mon Mar 27, 2017 3:34 pm
Has thanked: 1 time
Been thanked: 1 time

Serial commands

Thu May 25, 2017 3:43 pm

I was wondering what the command would be to run diagnostic? I am using Putty and am serialed in.

Julian
 

Re: Serial commands

Thu May 25, 2017 3:46 pm

our CLI is pretty much self-documented.. have you tried typing in a question mark?

User avatar
mike99
Associate
Associate
 
Posts: 837
Joined: Tue Nov 25, 2014 10:53 am
Location: Quebec, Canada
Has thanked: 95 times
Been thanked: 245 times

Re: Serial commands

Thu May 25, 2017 3:58 pm

Code: Select all
 show vlan

is a good start. It show you all vlans config and the management IP address.

rzoccola
Member
 
Posts: 7
Joined: Mon Mar 27, 2017 3:34 pm
Has thanked: 1 time
Been thanked: 1 time

Re: Serial commands

Thu May 25, 2017 3:59 pm

I just want to know the command to access this information:
2.png

User avatar
sirhc
Employee
Employee
 
Posts: 7347
Joined: Tue Apr 08, 2014 3:48 pm
Location: Lancaster, PA
Has thanked: 1597 times
Been thanked: 1317 times

Re: Serial commands

Thu May 25, 2017 4:00 pm

Yea pretty much typing "help" or "?" and pressing [Enter] at differnt points within the CLI tells you what commands are available at that point in the CLI.

For instance when you first login typing "help" or "?" and pressing [Enter] gives you this help.

Then I went into configuration mode and typed "help" again and pressed [Enter] and I got a list of valid commands at that point.

When you leave configuration mode any changes are saved and applied.

To leave configuration mode I simply pressed [Ctrl]+"z".

CLICK IMAGE BELOW TOP VIEW FULL SIZE
1.png
Support is handled on the Forums not in Emails and PMs.
Before you ask a question use the Search function to see it has been answered before.
To do an Advanced Search click the magnifying glass in the Search Box.
To upload pictures click the Upload attachment link below the BLUE SUBMIT BUTTON.

User avatar
sirhc
Employee
Employee
 
Posts: 7347
Joined: Tue Apr 08, 2014 3:48 pm
Location: Lancaster, PA
Has thanked: 1597 times
Been thanked: 1317 times

Re: Serial commands

Thu May 25, 2017 4:02 pm

rzoccola wrote:I just want to know the command to access this information:


I edited your post and uploaded the picture as your supposed to as instructed in the footer of my post(s):
To upload pictures click the Upload attachment link below the BLUE SUBMIT BUTTON.

That is an internal test routine we use, this is not available to the end user for many reasons.

However if you want to bench test your switch you should do as instructed in this post: viewtopic.php?f=6&t=2780#p19221
Support is handled on the Forums not in Emails and PMs.
Before you ask a question use the Search function to see it has been answered before.
To do an Advanced Search click the magnifying glass in the Search Box.
To upload pictures click the Upload attachment link below the BLUE SUBMIT BUTTON.

Return to General Discussion

Who is online

Users browsing this forum: No registered users and 37 guests