I had a switch die in storm running an older version of firmware I believe 1.3.8 maybe. Either way when I got the new switch in to replace it, it was running the newer 1.4.2 and it keeps rebooting back to default as it says it cannot communicate so it defaults. Is there a way to turn this feature off. We are running vlans so I cannot communicate directly plugged in, but I can plug it into my router and ssh and ping the device until it defaults after the default 60. I do not know why it is defaulting even when I can ping and ssh into it before it defaults. Please help as I do not want to keep the toughswitch in.
Thanks
Danny
WS-10-250-AC defaulting
-
legacyisp - Member
- Posts: 9
- Joined: Tue Oct 06, 2015 3:20 pm
- Location: Texas
- Has thanked: 0 time
- Been thanked: 0 time
-
sirhc - Employee
- Posts: 7347
- Joined: Tue Apr 08, 2014 3:48 pm
- Location: Lancaster, PA
- Has thanked: 1597 times
- Been thanked: 1318 times
Re: WS-10-250-AC defaulting
Go under the the Device/Configuration Tab and disable the Revert Timer by setting it to 0
After saving a config change if you do not log back in within the allotted time it reverts.
After saving a config change if you do not log back in within the allotted time it reverts.
Support is handled on the Forums not in Emails and PMs.
Before you ask a question use the Search function to see it has been answered before.
To do an Advanced Search click the magnifying glass in the Search Box.
To upload pictures click the Upload attachment link below the BLUE SUBMIT BUTTON.
Before you ask a question use the Search function to see it has been answered before.
To do an Advanced Search click the magnifying glass in the Search Box.
To upload pictures click the Upload attachment link below the BLUE SUBMIT BUTTON.
2 posts
Page 1 of 1
Who is online
Users browsing this forum: No registered users and 138 guests