Netonix Forums

HIKVision cameras work well with these switches. The outdoor PTZ cameras that require a "POE ++" injector work perfect with the 48VH poe output, and poe+ cameras all work well with 48V.

Cambium PTP 650 Integrated can be powered off 48VH with no issues at all.

Has anyone tried an old Trango Atlas 5010 or TLink-45? In the original post the Tycon PoE Crossover product is mentioned, which sounds like it would work. However as it's a Cambium compatible product I think doing the re-crimp like Matt mentions (crimp PINS 1,2,3,6 down properly, SWAP PIN 4 with 7 and 5 with 8) will work. I think doing that re-termination on both ends of the cable and then setting the Netonix port to 24v will do the job, but I would appreciate any feedback.

Thanks.

qlex wrote:Has anyone tried an old Trango Atlas 5010 or TLink-45? In the original post the Tycon PoE Crossover product is mentioned, which sounds like it would work. However as it's a Cambium compatible product I think doing the re-crimp like Matt mentions (crimp PINS 1,2,3,6 down properly, SWAP PIN 4 with 7 and 5 with 8) will work. I think doing that re-termination on both ends of the cable and then setting the Netonix port to 24v will do the job, but I would appreciate any feedback.

Thanks.

If you swapped both ends you would get no change.

You swap the pins on one side only.

Good point, lol. We'll give it a shot and report back. Thanks!

I can confirm that we have a Trango Atlas 5010 and TLink-45 5055 working via Netonix now. Thanks.

Can confirm newer Cambium 450i AP works ok at 48V.
This is different to standard 450 AP which should be powered up at 24V.

Anyone know if the Mimosa A5 can be powered with the WS-12-250-DC and if so, what power?

petecarlson wrote:Anyone know if the Mimosa A5 can be powered with the WS-12-250-DC and if so, what power?

Yes you can power any MIMOSA radio with 48V or preferably 48VH. The MIMOSA has a polarity correction circuits.

Ubiquiti Powerbridge M10 ??