Page 1 of 1

CLI command

Posted: Thu Mar 16, 2017 3:36 am
by nasked
Hi:

I usually use CLI interface with my smarthphone. Sometimes i need to make a port bounce. When type "show interface status" show me Port, Link, PoE and Watts. I need to see port name or description to find correct antenna to be rebooted.

Which command can i use to see ports name?

Thanks

Re: CLI command

Posted: Thu Mar 16, 2017 6:48 am
by mike99
I personnaly use "show configuration" but the're also lot of uneeded information when you only want the name of the port. That would maybe be a pain on a smarth phone.

Re: CLI command

Posted: Thu Mar 16, 2017 10:13 am
by Eric Stern
I'll add port name to 'show interface status'

Re: CLI command

Posted: Thu Mar 16, 2017 10:18 am
by nasked
Thanks and good job...