IP Problem

[Mola9850]

You're right it says unknown,

maybe Chris knows why ?? or what is going wrong??

[wayneorack]

You need to set the switch to use the static IP address!

You need to set all your switches to use a static IP address.

If all your switches are still set to 192.168.1.20, you have a big mess.

[Mola9850]

how and where do I find it, so it makes it do that??

But i have give it and ip. and all my switch have got a IP from 201 - 214

[sirhc]

As far as the unknown I have no idea, it should NEVER say this.

I will ask the programmer but I personally would factory default it and re set it back up or you can wait until Eric responds but this might be tomorrow.

[Mola9850]

Hi Chris
I just tried to reset one of the switch and program it again but same result, but will do some test but a new switch this afternoon.

[Mola9850]

Has
now made some tests in a few hours, and have found out that when I make my VLAN and save them, it write i status that my IP is unknown.

Here is a screenshot of before and after of before and after.

[Eric Stern]

I found the problem that causes IP Address "Unknown" if the default VLAN ID is not 1. This will be fixed in 1.1.1.

This only affects the display of the IP address in the UI and has nothing to do with the network problem you are having.

[Mola9850]

so you have no idea to what the problem is i have???

[Mola9850]

okay I just put the new firmware in the 2 netonix switch, and after I have done it,
sees everything Works as it should .

so there must be something in the file which rectifies the problem
.

[sirhc]

I am so glad this worked for you.