Netonix WS3-14-600-AC

DOWNLOAD THE LATEST FIRMWARE HERE
netblazr4
Member
 
Posts: 1
Joined: Mon Feb 22, 2021 4:08 pm
Has thanked: 0 time
Been thanked: 0 time

Netonix WS3-14-600-AC

Tue Feb 23, 2021 6:51 am

Hi,

I am experimenting with a Netonix WS3-14-600-AC switch running firmware 2.0.4 connected to a Mikrotik RB4011 with a 10G link.

At first, the 10G link would not come up. Disabled and enabled the link in vain. When I forced the interface of the RB4011 router
to negotiate a 1 Gbps link, the latter established. After that I put back the link on 10 Gbps and the link came up right away.

The second problem I encountered is that I could not power a Siklu radio using a cat 6A cable. The cable was testing fine.
The port would indicate OCP I believe.

As of yesterday night, even though the router interface to the Netonix switch shows up, I cannot ping the switch,
and the sub-interface I created on the 10 Gbps link is not carrying traffic. Prior to this the switch was reachable and the interface
carrying traffic for the last 10 days approximately after I kind of resolved the first problem.

Any thoughts?

Thanks,

User avatar
mike99
Associate
Associate
 
Posts: 766
Joined: Tue Nov 25, 2014 10:53 am
Location: Quebec, Canada
Has thanked: 92 times
Been thanked: 239 times

Re: Netonix WS3-14-600-AC

Tue Feb 23, 2021 8:32 am

Was the port forced at 10 Gb/s first ? Autoneg is not part of the SFP+ 10 Gb/s standard, only the 10 Gb/s copper standard that came later. On SFP+, you must generally force it on both end.

Return to Hardware and software issues

Who is online

Users browsing this forum: No registered users and 12 guests