Flow Control Grayed Out on Port 5
- Michael Day
- Member
- Posts: 15
- Joined: Wed Apr 12, 2017 10:35 am
- Has thanked: 0 time
- Been thanked: 0 time
Flow Control Grayed Out on Port 5
When I installed Firmware Version 1.4.7rc18 in my WS-12-250-AC, flow control on port turned gray and set itself to "none." When I went back to 1.4.6, flow control on port 5 indicates it has started working again. Has anyone else seen this?
-
sirhc - Employee
- Posts: 7489
- Joined: Tue Apr 08, 2014 3:48 pm
- Location: Lancaster, PA
- Has thanked: 1643 times
- Been thanked: 1336 times
Re: Flow Control Grayed Out on Port 5
Yes, because you have port bandwidth limiting set on that port.
I am guessing at this because you failed to post your TABs or explain all your configuration details in depth. I thought we did a mouse over balloon where the FC checkbox is greyed out?
If you have bandwidth limiting on a port then Flow Control should be disabled and greyed out.
This is not a bug but done by design.
I am guessing at this because you failed to post your TABs or explain all your configuration details in depth. I thought we did a mouse over balloon where the FC checkbox is greyed out?
If you have bandwidth limiting on a port then Flow Control should be disabled and greyed out.
This is not a bug but done by design.
Support is handled on the Forums not in Emails and PMs.
Before you ask a question use the Search function to see it has been answered before.
To do an Advanced Search click the magnifying glass in the Search Box.
To upload pictures click the Upload attachment link below the BLUE SUBMIT BUTTON.
Before you ask a question use the Search function to see it has been answered before.
To do an Advanced Search click the magnifying glass in the Search Box.
To upload pictures click the Upload attachment link below the BLUE SUBMIT BUTTON.
2 posts
Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest